Menu Close

Where to Find a Drain Trap For Your Bathroom

soakwells

A soaking tub is the best for cleansing yourself. But if you find that your bathtub suddenly freezes over or it won’t soak up water at all, then you must look for the causes of a problem. Get a drain trap. It will fix your problems!

The inner workings of a soaking tub are called bowls. If you think about it, each one has a bowl that is an inch or two wide.

When you fill up your tub with water, it will start to go into the inner bowl. As the water enters the inner bowl, it goes up the drainpipe and goes out into the water reservoir at the bottom of the bowl.

However, as the water begins to fill up a little bit, it causes the water to have a slight resistance to it. You know when the water is on the rise because it starts to move out of the inner bowl.

This resistance increases as the water goes deeper into the inner bowl. Eventually, the resistance gets too much and the water just can’t go any further.

The only way to get rid of this resistance from a soaking bowl is to turn off the pump that turns the inner bowl. As it turns off, it causes the inner bowl to not be able to work as fast. This means that the water is able to flow more quickly into the inner bowl.

But there’s more than just the inner bowl to worry about. The fact that your water has to travel faster through the inner bowl means that it doesn’t get soaked anymore and will drain faster than before.

So if you’ve noticed that your water is running out too fast, then you should really be thinking about getting a pump to make sure that you have clean water in the next soak. It will solve all your problems.

Push a pin in the bottom of the inner bowl and leave it there. That will give you a problem-free tub again.

Have you ever tried to do this? You’ll need some material that is round and has a small hole drilled in it.

Now drill a hole through the top of the material and get it wet with warm water. Put the pin in the hole and it will push the material down so that the whole inner bowl can get the water.

When you push it into the hole, it will actually make a snapping sound when it gets forced into the inner bowl. But once it’s done, it will push the material back out into the water reservoir and you will see that there’s a big difference. If you do not want to risk ruining it get in contact with professionals at Soakwells Perth.